SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS REDREPAIR AND DIAGNOSISSTEERINGPOWER STEERINGSTEERING SYSTEMCOLUMNREMOVAL AND INSTALLATIONINSTALLATION
2023 Jeep Compass Red

Removal And Installation: Installation

2023 Jeep Compass RedSECTION Installation
GC0188366Courtesy of CHRYSLER GROUP, LLC
  1. Position the steering column (3) in the vehicle.
  2. Install the two front steering column support bolts (2) and tighten them to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
  3. Install the two rear steering column support nuts (1) and tighten them to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
    GC0179422Courtesy of CHRYSLER GROUP, LLC
  4. Install the intermediate shaft (2) to the steering gear.
  5. Install a NEW  intermediate shaft pinch bolt (1) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
  6. Install the Steering Column Control Module (SCCM). Refer to MODULE, STEERING COLUMN CONTROL (SCCM), REMOVAL AND INSTALLATION .
  7. Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .
  8. Install the steering wheel. Refer to WHEEL, STEERING, REMOVAL AND INSTALLATION .
  9. Connect the negative battery cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.