Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal And Installation: Installation
2023 Jeep Compass RedSECTION Installation
- Position the seat belt turning loop adjuster (2) to the inside of the B-pillar.
- Install the mounting bolts (1) that secure the adjuster (2) to the B-pillar and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
- Install the upper B-pillar trim. Refer to
PANEL, B-PILLAR TRIM, UPPER, REMOVAL AND INSTALLATION
.
- Position the seat belt turning loop (2) to the height adjuster on the upper B-pillar. Be certain that the seat belt webbing between the retractor and the turning loop is not twisted.
- Install the mounting nut (1) that secures the turning loop to the height adjuster and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
- Snap the trim cover (1) to the height adjuster on the upper B-pillar.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.