Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS REDREPAIR AND DIAGNOSISELECTRICALBODY ELECTRICALPOWER DISTRIBUTIONMODULE, WIRELESS CHARGING PADREMOVAL AND INSTALLATIONINSTALLATION
2023 Jeep Compass Red
Removal And Installation: Installation
2023 Jeep Compass RedSECTION Installation
- Position the wireless charging pad module (2) to the wireless charging bracket (3), then install the fasteners (1) and tighten them securely.
- Position the wireless charging module bracket into the floor console.
- Connect the wire harness connector (3) to the wireless charging pad module.
- Slide the tab on the front of the wireless charging module bracket (1) into the slot on the front of the floor console.
- Lower the rear of the wireless charging bracket until the retaining tabs (2) are fully engaged into the floor console.
- Install the wireless charging pad mat (1).
- Install the shifter bezel. Refer to BEZEL, SHIFTER, REMOVAL AND INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.