Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS REDREPAIR AND DIAGNOSISBODY & FRAMESEATS(MEMORY SEATS MODULE (DRIVER) (MSMD) - ELECTRICAL DIAGNOSTICS)
2023 Jeep Compass Red
(Memory Seats Module (Driver) (MSMD) - Electrical Diagnostics)
2023 Jeep Compass RedSECTION (Memory Seats Module (Driver) (MSMD) - Electrical Diagnostics)
- Diagnostic Code Index
- DTC Troubleshooting
- B1D5E-13-Power Seat Switch - Circuit Open
- B1D62-2A-Power Seat Switch Stuck-Stuck
- B1D6B-11-Seat Horizontal Position Sensor - Circuit Short To Ground
- B1D6B-12-Seat Horizontal Position Sensor - Circuit Short To Battery
- B1D6F-11-Seat Front Vertical Position Sensor - Circuit Short To Ground
- B1D6F-12-Seat Front Vertical Position Sensor - Circuit Short To Battery
- B1D73-11-Seat Rear Vertical Position Sensor - Circuit Short To Ground
- B1D73-12-Seat Rear Vertical Position Sensor - Circuit Short To Battery
- B1D77-11-Seat Recliner Position Sensor - Circuit Short To Ground
- B1D77-12-Seat Recliner Position Sensor - Circuit Short To Battery
- B1D7B-00-Seat Horizontal Motor Control Circuit Performance
- B1D7F-00-Seat Front Vertical Motor Control Circuit Performance
- B1D83-00-Seat Rear Vertical Motor Control Circuit Performance
- B1D87-00-Seat Backrest Motor Control - Circuit Performance
- B1D9B-54-Seat Horizontal Front Stop Not Learned-Missing Calibration
- B210A-84-System Voltage Low-Signal Below Allowable Range
- B210B-85-System Voltage High - Signal Above Allowable Range
- B210D-21-Battery Voltage Low - Signal Amplitude Minimum
- B210E-22-Battery Voltage High - Signal Amplitude > Maximum
- B221C-42-(MSM) Memory Seat Module Internal-General Memory Failure
- B222D-00-Ecu Unable To Configure/Configuration Not Learned
- U0011-00-Can Interior Bus Off Performance
- U0140-00-Lost Communication With Body Control Module
- U0155-00-Lost Communication With Cluster-CCN
- U0184-00-Lost Communication With Radio
- U0422-00-Implausible Data Received From Body Control Module
- U0423-00-Implausible Data Received From Cluster-CCN
- U0485-00-Implausible Data Received From Radio
- Standard Procedure
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.