Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS REDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCE(CENTRAL VISION PROCESSING MODULE (CVPM) - ELECTRICAL DIAGNOSTICS)
2023 Jeep Compass Red
(Central Vision Processing Module (CVPM) - Electrical Diagnostics)
2023 Jeep Compass RedSECTION (Central Vision Processing Module (CVPM) - Electrical Diagnostics)
- Diagnostic Code Index
- DTC Troubleshooting
- B217A-1C-Rear Camera-Circuit Voltage Out Of Range
- B217A-92-Rear Camera-Performance Or Incorrect Operation
- B2199-16-Battery Voltage - Circuit Voltage Below Threshold
- B2199-17 - Battery Voltage-Circuit Voltage Above Threshold
- B21DD-84 System Voltage-Signal Below Allowable Range
- B21DD-85 System Voltage-Signal Above Allowable Range
- B222E-00-Flash Checksum Performance
- B223B-00 - Vehicle Configuration Mismatch
- B2286-00-Calibration Not Learned-Lost Calibration
- B22A9-00 - Ecu Internal Performance
- B23C5-1C-Front Camera-Circuit Voltage Out Of Range
- B23C5-92-Front Camera-Performance Or Incorrect Operation
- B23C6-1C-Left Camera-Circuit Voltage Out Of Range
- B23C6-92-Left Camera-Performance Or Incorrect Operation
- B23C7-1C-Right Camera-Circuit Voltage Out Of Range
- B23C7-92-Right Camera-Performance Or Incorrect Operation
- U0010-00-Can Interior Bus
- U0140-00-Lost Communication With Body Control Module
- U0184-00-Lost Communication With Radio
- U0264-00-Lost Communication With Camera Module-Rear
- U0265-00-Lost Communication With Front Camera
- U0266-00-Lost Communication With Left Camera
- U0267-00-Lost Communication With Right Camera
- U0422-00-Invalid Data Received From Body Control Module
- U0485-00-Implausible Data Received From Radio
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.