Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS REDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX (2 OF 2)MODULE, POWER LIFTGATE (PLGM)
2023 Jeep Compass Red
Module, Power Liftgate (PLGM)
2023 Jeep Compass RedSECTION Module, Power Liftgate (PLGM)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B1882-92 | LIFTGATE POSITION SENSOR 1-PERFORMANCE OR INCORRECT OPERATION |
| B1886-11 | LIFTGATE PINCH SENSOR 1-CIRCUIT SHORT TO GROUND |
| B1886-12 | LIFTGATE PINCH SENSOR 1-CIRCUIT SHORT TO BATTERY |
| B188C-11 | LIFTGATE CONTROL CIRCUIT 1-CIRCUIT SHORT TO GROUND |
| B188C-12 | LIFTGATE CONTROL CIRCUIT 1-CIRCUIT SHORT TO BATTERY |
| B188C-13 | LIFTGATE CONTROL CIRCUIT 1-CIRCUIT OPEN |
| B18E1-12 | POWER LIFTGATE FRONT ZONE SWITCH-CIRCUIT SHORT TO BATTERY |
| B18E1-2A | POWER LIFTGATE FRONT ZONE SWITCH-STUCK |
| B1941-92 | POWER LIFTGATE POSITION SENSOR 2-PERFORMANCE OR INCORRECT OPERATION |
| B1945-11 | POWER LIFTGATE PINCH SENSOR 2-CIRCUIT SHORT TO GROUND |
| B1945-12 | POWER LIFTGATE PINCH SENSOR 2-CIRCUIT SHORT TO BATTERY |
| B1949-12 | POWER LIFTGATE REAR ZONE SWITCH-CIRCUIT SHORT TO BATTERY |
| B1949-2A | POWER LIFTGATE REAR ZONE SWITCH-STUCK |
| B1952-00 | POWER LIFTGATE DRIVE MOTOR - INCORRECT DIRECTION |
| B1957-11 | POWER LIFTGATE DRIVE CLUTCH CONTROL-CIRCUIT SHORT TO GROUND |
| B1957-12 | POWER LIFTGATE DRIVE CLUTCH CONTROL-CIRCUIT SHORT TO BATTERY |
| B195F-11 | POWER LIFTGATE CHIME CONTROL-CIRCUIT SHORT TO GROUND |
| B195F-12 | POWER LIFTGATE CHIME CONTROL-CIRCUIT SHORT TO BATTERY |
| B1963-00 | POWER LIFTGATE STRUT PERFORMANCE |
| B1964-11 | POWER LIFTGATE SENSOR SUPPLY-CIRCUIT SHORT TO GROUND |
| B1964-12 | POWER LIFTGATE SENSOR SUPPLY-CIRCUIT SHORT TO BATTERY |
| B1967-00 | POWER LIFTGATE OPEN DIRECTION OVERCURRENT |
| B196A-00 | POWER LIFTGATE CLOSE DIRECTION OVERCURRENT |
| B197B-29 | RATCHET FORK SWITCH-SIGNAL INVALID |
| B197C-29 | PAWL DETENT SWITCH-SIGNAL INVALID |
| B197D-29 | GEAR POSITION SWITCH 1-SIGNAL INVALID |
| B197E-29 | GEAR POSITION SWITCH 2-SIGNAL INVALID |
| B197F-11 | POWER LIFTGATE LATCH CONTROL 1-CIRCUIT SHORT TO GROUND |
| B197F-12 | POWER LIFTGATE LATCH CONTROL 1-CIRCUIT SHORT TO BATTERY |
| B197F-13 | POWER LIFTGATE LATCH CONTROL 1-CIRCUIT OPEN |
| B2199-16 | BATTERY VOLTAGE-CIRCUIT VOLTAGE BELOW THRESHOLD |
| B2199-17 | BATTERY VOLTAGE-CIRCUIT VOLTAGE ABOVE THRESHOLD |
| B21DD-16 | SYSTEM VOLTAGE-CIRCUIT VOLTAGE BELOW THRESHOLD |
| B21DD-17 | SYSTEM VOLTAGE-CIRCUIT VOLTAGE ABOVE THRESHOLD |
| B224E-00 | POWER LIFTGATE MODULE INTERNAL |
| U0010-00 | CAN INTERIOR BUS |
| U0011-00 | CAN INTERIOR BUS OFF PERFORMANCE |
| U0140-00 | LOST COMMUNICATION WITH BODY CONTROL MODULE |
| U0155-00 | LOST COMMUNICATION WITH CLUSTER-CCN |
| U0422-00 | INVALID DATA RECEIVED FROM BODY CONTROL MODULE |
| U0423-00 | IMPLAUSIBLE DATA RECEIVED FROM CLUSTER-CCN |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.