Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS LIMITEDREPAIR AND DIAGNOSISELECTRICALBODY ELECTRICALPOWER DISTRIBUTIONMODULE, WIRELESS CHARGING PADREMOVAL AND INSTALLATIONREMOVAL
2023 Jeep Compass Limited
Removal And Installation: Removal
2023 Jeep Compass LimitedSECTION Removal
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the shifter bezel. Refer to BEZEL, SHIFTER, REMOVAL AND INSTALLATION
.
- Remove the wireless charging pad mat (1).
- Release the retaining tabs (2) and lift up on the rear of the wireless charging module bracket (1).
- Slide the bracket (1) toward the rear of the vehicle to release it from the front of the floor console.
- Disconnect the wire harness connector (3) from the wireless charging pad module.
- Remove the fasteners (1) from the wireless charging module (2) and remove it from the wireless charging module bracket (3).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.