Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS LIMITEDREPAIR AND DIAGNOSISELECTRICALBODY ELECTRICALPOWER DISTRIBUTIONFUSE, Z-CASE ARRAYREMOVAL AND INSTALLATIONZ-CASE FUSE ARRAYINSTALLATION
2023 Jeep Compass Limited
Z-Case Fuse Array: Installation
2023 Jeep Compass LimitedSECTION Installation
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Position the PDC wire harness connector onto the PDC.
- Secure the PDC to the lower tray by engaging all the latches on to the lock tabs.
- Tighten the nuts to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
- Install the PDC cover onto the PDC assembly until the latches fully engage the lock tabs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.