Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS LATITUDEREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX (2 OF 2)MODULE, MEMORY SEAT, DRIVER (MSMD)
2023 Jeep Compass Latitude
Module, Memory Seat, Driver (MSMD)
2023 Jeep Compass LatitudeSECTION Module, Memory Seat, Driver (MSMD)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B1D5E-13 | POWER SEAT SWITCH - CIRCUIT OPEN |
| B1D62-2A | POWER SEAT SWITCH STUCK-STUCK |
| B1D6B-11 | SEAT HORIZONTAL POSITION SENSOR - CIRCUIT SHORT TO GROUND |
| B1D6B-12 | SEAT HORIZONTAL POSITION SENSOR - CIRCUIT SHORT TO BATTERY |
| B1D6F-11 | SEAT FRONT VERTICAL POSITION SENSOR - CIRCUIT SHORT TO GROUND |
| B1D6F-12 | SEAT FRONT VERTICAL POSITION SENSOR - CIRCUIT SHORT TO BATTERY |
| B1D73-11 | SEAT REAR VERTICAL POSITION SENSOR - CIRCUIT SHORT TO GROUND |
| B1D73-12 | SEAT REAR VERTICAL POSITION SENSOR - CIRCUIT SHORT TO BATTERY |
| B1D77-11 | SEAT RECLINER POSITION SENSOR - CIRCUIT SHORT TO GROUND |
| B1D77-12 | SEAT RECLINER POSITION SENSOR - CIRCUIT SHORT TO BATTERY |
| B1D7B-00 | SEAT HORIZONTAL MOTOR CONTROL CIRCUIT PERFORMANCE |
| B1D7F-00 | SEAT FRONT VERTICAL MOTOR CONTROL CIRCUIT PERFORMANCE |
| B1D83-00 | SEAT REAR VERTICAL MOTOR CONTROL CIRCUIT PERFORMANCE |
| B1D87-00 | SEAT BACKREST MOTOR CONTROL - CIRCUIT PERFORMANCE |
| B1D9B-54 | SEAT HORIZONTAL FRONT STOP NOT LEARNED-MISSING CALIBRATION |
| B210A-84 | SYSTEM VOLTAGE LOW-SIGNAL BELOW ALLOWABLE RANGE |
| B210B-85 | SYSTEM VOLTAGE HIGH - SIGNAL ABOVE ALLOWABLE RANGE |
| B210D-21 | BATTERY VOLTAGE LOW - SIGNAL AMPLITUDE MINIMUM |
| B210E-22 | BATTERY VOLTAGE HIGH - SIGNAL AMPLITUDE > MAXIMUM |
| B221C-42 | (MSM) MEMORY SEAT MODULE INTERNAL-GENERAL MEMORY FAILURE |
| B222D-00 | ECU UNABLE TO CONFIGURE/CONFIGURATION NOT LEARNED |
| U0011-00 | CAN INTERIOR BUS OFF PERFORMANCE |
| U0140-00 | LOST COMMUNICATION WITH BODY CONTROL MODULE |
| U0155-00 | LOST COMMUNICATION WITH CLUSTER-CCN |
| U0184-00 | LOST COMMUNICATION WITH RADIO |
| U0422-00 | IMPLAUSIBLE DATA RECEIVED FROM BODY CONTROL MODULE |
| U0423-00 | IMPLAUSIBLE DATA RECEIVED FROM CLUSTER-CCN |
| U0485-00 | IMPLAUSIBLE DATA RECEIVED FROM RADIO |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.