Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS LATITUDEREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX (1 OF 2)MODULE, ELECTRONIC SHIFT (ESM)
2023 Jeep Compass Latitude
Module, Electronic Shift (ESM)
2023 Jeep Compass LatitudeSECTION Module, Electronic Shift (ESM)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| P0562-00 | SYSTEM VOLTAGE LOW |
| P0563-00 | SYSTEM VOLTAGE HIGH |
| P0606-00 | INTERNAL CONTROL PROCESSOR |
| P0607-00 | ECU INTERNAL PERFORMANCE - ESM |
| P060A-00 | INTERNAL CONTROL MODULE MONITORING PROCESSOR PERFORMANCE |
| P0814-00 | TRANSMISSION RANGE DISPLAY CIRCUIT |
| P081C-00 | PARK INPUT CIRCUIT |
| P0826-00 | UP/DOWN SHIFT SWITCH CIRCUIT |
| P0914-00 | GEAR SHIFT POSITION CIRCUIT (LIGHT FAULT) |
| P0919-00 | GEAR SHIFT POSITION CONTROL ERROR |
| P0928-00 | BTSI CONTROL |
| P0929-00 | GEAR SHIFT LOCK SOLENOID-ACTUATOR CONTROL CIRCUIT 1 RANGE-PERFORMANCE |
| P0955-00 | AUTO SHIFT MANUAL MODE CIRCUIT ERS SWITCH |
| P09A1-00 | UP DOWN SHIFT SWITCH CIRCUIT PERFORMANCE |
| P1C73-00 | PARK SWITCH CIRCUIT STUCK |
| P1C82-00 | AUTOSTICK CIRCUIT PERFORMANCE |
| P1CA7-00 | IGNITION SOLENOID CONTROL CIRCUIT HIGH OR OPEN |
| P1CA8-00 | IGNITION SOLENOID CONTROL CIRCUIT LOW |
| U0001-00 | CAN C BUS |
| U0100-00 | LOST COMMUNICATION WITH ECM/PCM |
| U0101-00 | LOST COMMUNICATION WITH TCM |
| U0129-00 | LOST COMMUNICATION WITH BRAKE SYSTEM CONTROL MODULE |
| U0140-00 | LOST COMMUNICATION WITH BODY CONTROL MODULE |
| U0155-00 | LOST COMMUNICATION WITH CLUSTER-CCN |
| U0401-00 | IMPLAUSIBLE DATA RECEIVED FROM ECM/PCM |
| U0402-00 | INVALID DATA RECEIVED FROM TCM |
| U0415-00 | IMPLAUSIBLE DATA RECEIVED FROM ABS |
| U0422-00 | INVALID DATA RECEIVED FROM BODY CONTROL MODULE |
| U0423-00 | IMPLAUSIBLE DATA RECEIVED FROM CLUSTER-CCN |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.