Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS LATITUDEREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX (1 OF 2)MODULE, DIGITAL TV
2023 Jeep Compass Latitude
Module, Digital TV
2023 Jeep Compass LatitudeSECTION Module, Digital TV
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B1499-11 | TV ANTENNA 1-CIRCUIT SHORT TO GROUND |
| B1499-12 | TV ANTENNA 1-CIRCUIT SHORT TO BATTERY |
| B1499-13 | TV ANTENNA 1-CIRCUIT OPEN |
| B149B-11 | TV ANTENNA 2-CIRCUIT SHORT TO GROUND |
| B149B-12 | TV ANTENNA 2-CIRCUIT SHORT TO BATTERY |
| B149B-13 | TV ANTENNA 2-CIRCUIT OPEN |
| B1550-4B | DIGITAL TELEVISION MODULE-OVER TEMPERATURE |
| B2199-16 | BATTERY VOLTAGE-CIRCUIT VOLTAGE BELOW THRESHOLD |
| B2199-17 | BATTERY VOLTAGE-CIRCUIT VOLTAGE ABOVE THRESHOLD |
| B21DD-84 | SYSTEM VOLTAGE-SIGNAL BELOW ALLOWABLE RANGE |
| B21DD-85 | SYSTEM VOLTAGE-SIGNAL ABOVE ALLOWABLE RANGE |
| B2206-00 | CURRENT VIN MISSING / MISMATCH |
| B222C-00 | VEHICLE CONFIGURATION NOT PROGRAMMED |
| B22A9-00 | ECU INTERNAL PERFORMANCE |
| B23C4-31 | SIDE CAMERA-NO SIGNAL |
| B23C5-31 | FRONT CAMERA-NO SIGNAL |
| U0010-00 | CAN INTERIOR BUS |
| U0011-00 | CAN INTERIOR BUS OFF PERFORMANCE |
| U0140-00 | LOST COMMUNICATION WITH BODY CONTROL MODULE |
| U0184-00 | LOST COMMUNICATION WITH RADIO |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.