Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS ALTITUDEREPAIR AND DIAGNOSISSTEERINGSTEERING COLUMNSTEERING SYSTEMCOLUMNSHAFT, INTERMEDIATEREMOVAL AND INSTALLATIONREMOVAL
2023 Jeep Compass Altitude
Removal And Installation: Removal
2023 Jeep Compass AltitudeSECTION Removal
- Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .
- Disconnect the two Electric Power Steering (EPS) module electrical connectors.
- Remove the two front steering column bolts (2).
- Remove the two rear steering column nuts (1), and lower the steering column (3).
- Place the steering wheel in a position which allows access to the intermediate shaft coupler pinch bolt (1).
- Remove and DISCARD the intermediate shaft coupler pinch bolt (1) from the steering column end of the shaft.
- Secure the steering wheel with the tires in the straight ahead position.NOTE:
Some vehicles may not be equipped with an internal locking shaft that allows the ignition key cylinder to be locked with the key. Alternative methods of locking the steering wheel for service will have to be used.
- Remove and DISCARD the intermediate shaft coupler pinch bolt (3) from the steering gear end of the shaft.
- Slide the intermediate shaft coupler off of the steering gear.
- Slide the intermediate shaft coupler off of the steering column.
- Remove the intermediate shaft (2).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.