Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS ALTITUDEREPAIR AND DIAGNOSISSTEERINGMANUAL STEERINGSTEERING SYSTEMTECHNICAL SPECIFICATIONSTORQUE SPECIFICATIONS
2023 Jeep Compass Altitude
Torque Specifications
2023 Jeep Compass AltitudeSECTION Torque Specifications
TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | COMMENT |
|---|---|---|---|---|
| Heat Shield Bolts | 9 | 7 | - | |
| Intermediate Shaft Pinch Bolts | 50 | 37 | - | Do NOT reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Outer Tie Rod End Nut (Aluminum Knuckle) | 30 + 180° | 22 + 180° | - | Do NOT reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Outer Tie Rod End Nut (Iron Knuckle) | 25 + 185° | 18 + 185° | - | Do NOT reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Steering Column Bolts | 22 | 16 | - | |
| Steering Column Nuts | 22 | 16 | - | |
| Steering Gear Bolts | 90 | 66 | - | |
| Steering Wheel Nut | 50 | 37 | - | Do NOT reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Tie Rod Jam Nut | 81 | 60 | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.