Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS ALTITUDEREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEM2.0L - DTCS P2096 TO P2173
2023 Jeep Compass Altitude
2.0L - DTCS P2096 To P2173
2023 Jeep Compass AltitudeSECTION 2.0L - DTCS P2096 To P2173
- DTC Troubleshooting
- P2096-Downstream Fuel Trim System 1 Lean
- P2097-Downstream Fuel Trim System 1 Rich
- P2100-Electronic Throttle Control Motor Circuit/Open - Bank1
- P2101-Electronic Throttle Control Motor Performance - Bank 1
- P2107-Electronic Throttle Control Module Processor
- P2110-Electronic Throttle Control System Bank 1 - Forced Limited Rpm
- P2111-Electronic Throttle Control System - Unable To Close - Bank 1
- P2112-Electronic Throttle Control System - Unable To Open - Bank 1
- P2115-Accelerator Pedal Position Sensor 1 Minimum Stop Performance
- P2116-Accelerator Pedal Position Sensor 2 Minimum Stop Performance
- P2118-Electronic Throttle Control Motor Current Performance - Bank 1
- P2122-Accelerator Pedal Position Sensor 1 Circuit Low
- P2123-Accelerator Pedal Position Sensor 1 Circuit High
- P2127-Accelerator Pedal Position Sensor 2 Circuit Low
- P2128-Accelerator Pedal Position Sensor 2 Circuit High
- P2135-Throttle Position Sensor 1 / 2 Correlation
- P2138-Accelerator Pedal Position Sensor 1 / 2 Correlation
- P2146-Fuel Injector Group 1 Supply Voltage Circuit/Open
- P2166-Accelerator Pedal Position Sensor 1 Maximum Stop Performance
- P2167-Accelerator Pedal Position Sensor 2 Maximum Stop Performance
- P2172-High Airflow/Vacuum Leak Detected (Instantaneous Accumulation)
- P2173-High Airflow/Vacuum Leak Detected (Slow Accumulation)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.