Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS ALTITUDEREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSPOWER WINDOWS (SERVICE INFORMATION)SWITCH, POWER WINDOWREMOVAL AND INSTALLATIONINSTALLATION
2023 Jeep Compass Altitude
Removal And Installation: Installation
2023 Jeep Compass AltitudeSECTION Installation
- Position the switch bank (2) into the switch bezel (1), and fully engage all the switch bezel retaining clips.
- Connect the wiring harness connectors.
- Install the switch bank assembly (2) back into the door panel (1).
- Install the bolt (3) and the cover (2) into the door panel (1).
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.