Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Auto-Up/Down Relearn Procedure
This procedure is for either driver or passenger door on vehicles equipped with the Auto-Up/Down feature. Perform the procedure using the window switch bank on the door that needs to have this window feature relearned.
To relearn the Auto-Down/Auto-Up feature, perform the following procedure:
RELEARN PROCEDURE
- Using the appropriate power window switch bank, position the window to the full closed position and while continuing to hold the window switch up for an additional two seconds after the window has closed.
- Using the same power window switch bank, position the window to the full open position and continue to hold the switch down after the window is full open for an additional two seconds.
- Relearn is now complete. Verify the Auto-Up/Down feature is operational.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.