Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023COMPASS ALTITUDELABOR TIMESENGINE MECHANICALMECHANICALTIMING CHAINREMOVE & REPLACE
2023 Jeep Compass Altitude
Timing Chain: Remove & Replace
2023 Jeep Compass AltitudeSECTION Remove & Replace
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 7.9 | B | |||
| Combination Procedure: BALANCE SHAFT SPROCKET: Remove & Replace: | ||||
| Includes: R&I Oil Pump Drive Chain. | 0.7 | B | ||
| Combination Procedure: CAMSHAFT GEAR OR SPROCKET: Remove & Replace: | ||||
| Each | DOES NOT include Calibration. | 0.2 | B | |
| Combination Procedure: CRANKSHAFT GEAR OR SPROCKET: Remove & Replace: | ||||
| Includes: R&I Oil Pump Drive Chain. | 0.6 | B | ||
| Combination Procedure: CRANKSHAFT POSITION SENSOR: Calibrate: | ||||
| Cam/Crank Variation Relearn | Includes: Additional time for use of scan tool to perform this procedure. | 0.2 | B | |
| Combination Procedure: OIL PUMP DRIVE CHAIN: Remove & Replace: | ||||
| 0.5 | B | |||
| Combination Procedure: OIL PUMP DRIVE CHAIN TENSIONER: Remove & Replace: | ||||
| 0.2 | B | |||
| Combination Procedure: TIMING CHAIN GUIDE: Remove & Replace: | ||||
| Each | 0.1 | B | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.