Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2023CHEROKEE TRAILHAWKREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERY2.0L FUEL SYSTEMFUEL DELIVERY, GASMODULE, FUEL PUMP, CONTROLINSTALLATION
2023 Jeep Cherokee Trailhawk
Module, Fuel Pump, Control: Installation
2023 Jeep Cherokee TrailhawkSECTION Installation
- Position the Fuel Pump Control Module (FPCM) (1) onto the studs and install nuts (2) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
- Connect the FPCM wire harness connector.
- Install quarter trim panel. Refer to PANEL, QUARTER TRIM, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.