2022 Jeep Compass RedFACTORY OEM SERVICE PROCEDURE

Torque Specifications

WARNING: This page is about a different car, the 2021 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATION

DESCRIPTION N.m Ft. Lbs. In. Lbs. COMMENT
Heat Shield Bolts 9 7 -  
Intermediate Shaft Pinch Bolts 60 44 - Do NOT  reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
Outer Tie Rod End Nut (Aluminum Knuckle) 30 + 180° 22 + 180° - Do NOT  reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
Outer Tie Rod End Nut (Iron Knuckle) 25 + 185° 18 + 185° - Do NOT  reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
Steering Column Bolts 22 16 -  
Steering Column Nuts 22 16 -  
Steering Gear Bolts 110 81 -  
Steering Wheel Nut 52 38 - Do NOT  reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
Tie Rod Jam Nut 98 72 -  
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.