Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Jeep Compass RedFACTORY OEM SERVICE PROCEDURE
Removal And Installation: Installation
WARNING: This page is about a different car, the 2021 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
- If removed, connect the wire harness connector for the speed control switch.
- Position the wire harness in the steering wheel following the correct routing and secure the wire harness in the retainers.
- Position the speed control switch to the steering wheel, then install and securely tighten the screw.
- Connect the remote radio switch wire harness connector and position the wire harness in the retainers.
- Position the remote radio switch on the steering wheel, then install and securely tighten the screw.
- Install the remote radio switch trim cover.
- Repeat Steps 2 through 7 for the switches mounted on the left side of the steering wheel.
- Position the steering wheel to the steering column and connect the wire harness connector for the SCCM.
- Properly align the steering wheel to the steering column shaft and install it on the shaft.
- Install the steering wheel nut and torque the nut to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
- Install the cover for the nut on the steering column shaft.
- Install the DAB. Refer to AIR BAG, DRIVER, REMOVAL AND INSTALLATION .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
