2022 Jeep Compass RedFACTORY OEM SERVICE PROCEDURE

Removal And Installation: 1.4L: Removal

WARNING: This page is about a different car, the 2021 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION or COVER, ENGINE, REMOVAL AND INSTALLATION or COVER, ENGINE, REMOVAL AND INSTALLATION .
    GC0165195Courtesy of CHRYSLER GROUP, LLC
  3. Remove the bolts (1a) and the heat shield (1b).
    GC0164106Courtesy of CHRYSLER GROUP, LLC
  4. Remove the bolts (1a), the nut (1b) and the turbocharger support bracket (1c).
    GC0164126Courtesy of CHRYSLER GROUP, LLC
  5. Remove the bolts (1a) and the turbocharger heat shield (1b).
    GC0164116Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the upstream oxygen sensor wiring to the catalytic converter from the upper retaining clip (1).
    GC0164431Courtesy of CHRYSLER GROUP, LLC
  7. Loosen the bolt (1) securing the catalytic converter to the turbocharger.
    GC0165230Courtesy of CHRYSLER GROUP, LLC
  8. Detach the wiring from the spring retainer (1).
  9. Disconnect the oxygen sensor wire harness connector (2).
    GC0165969Courtesy of CHRYSLER GROUP, LLC
  10. Detach the wiring from the spring retainer (1).
  11. Disconnect the front oxygen sensor wire harness connector (2) at the catalytic converter.
    GC0164985Courtesy of CHRYSLER GROUP, LLC
  12. Remove the rear exhaust pipe support bracket bolts (1).
    GC0165545Courtesy of CHRYSLER GROUP, LLC
  13. Remove the bolts (1) securing the front exhaust pipe support bracket.
  14. Remove the bolt (2) securing the exhaust pipe to the engine oil pan.
    GC0165208Courtesy of CHRYSLER GROUP, LLC
  15. Remove the nuts and disengage the exhaust pipe from the catalytic converter (1).
  16. Remove the gasket.
    GC0163590Courtesy of CHRYSLER GROUP, LLC
  17. Remove the bolts (1a) and the catalytic converter with brackets (1b).
  18. Remove the turbocharger-to-catalytic converter gasket.
    GC0165186Courtesy of CHRYSLER GROUP, LLC
  19. Remove the bolts (1a) and the catalytic converter brackets (1b).
    GC0164996Courtesy of CHRYSLER GROUP, LLC
  20. Remove the nuts (1a) and the heat shield (1b) from the catalytic convertor.
    GC0164750Courtesy of CHRYSLER GROUP, LLC
  21. Remove the upstream oxygen sensor (1) from the catalytic converter.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.