Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Jeep Compass RedFACTORY OEM SERVICE PROCEDURE
2.4L - DTCS P06E9 To P103B
- DTC Troubleshooting
- P06E9-Engine Starter Performance
- P06EF-Engine Restart Performance
- P0703-Brake Switch 2 Performance
- P0780-Gear Shift Malfunction
- P0784-4/5 Shift
- P0806-Clutch Position Sensor 1 Circuit Performance
- P0807-Clutch Position Sensor "A" Circuit Low
- P0808-Clutch Position Sensor "A" Circuit High
- P080A-Clutch POSTION Not Learned
- P082E-Gear Lever Y Position Sensor 1 Circuit Low
- P082F-Gear Lever Y Position Sensor 1 Circuit High
- P0850-Park/Neutral Switch Performance
- P1031-Cylinder 1 Oil Supply Solenoid Valve Driver Voltage Implausible
- P1032-Cylinder 2 Oil Supply Solenoid Valve Driver Voltage Implausible
- P1033-Cylinder 3 Oil Supply Solenoid Valve Driver Voltage Implausible
- P1034-Cylinder 4 Oil Supply Solenoid Valve Driver Voltage Implausible
- P1035-Cylinder 1 Oil Supply Solenoid Valve Open Circuit
- P1036-Cylinder 1 Oil Supply Solenoid Valve Driver Short To Battery
- P1037-Cylinder 1 Oil Supply Solenoid Valve Driver Short To Ground
- P1038-Cylinder 2 Oil Supply Solenoid Valve Driver Open Circuit
- P1039-Cylinder 2 Oil Supply Solenoid Valve Driver Short To Battery
- P103A-Cylinder 2 Oil Supply Solenoid Valve Driver Short To Ground
- P103B-Cylinder 3 Oil Supply Solenoid Valve Driver Open Circuit
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
