Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Jeep Compass RedFACTORY OEM SERVICE PROCEDURE
2.4L - DTCS P0135 To P0302
- DTC Troubleshooting
- P0135-O2 Sensor 1/1 Heater Performance
- P0137-O2 Sensor 1/2 Circuit Low
- P0138-O2 Sensor 1/2 Circuit High
- P0139-O2 Sensor 1/2 Slow Response
- P0140-O2 Sensor 1/2 Signal Inactive
- P0141-O2 Sensor 1/2 Heater Performance
- P0171-Fuel System 1/1 Lean
- P0172-Fuel System 1/1 Rich
- P0196-Engine Oil Temperature Sensor Performance
- P0197-Engine Oil Temperature Sensor Circuit Low
- P0198-Engine Oil Temperature Sensor Circuit High
- P0199-Engine Oil Temperature Sensor Circuit Intermittent
- P0201-Fuel Injector 1 Circuit/Open
- P0202-Fuel Injector 2 Circuit/Open
- P0203-Fuel Injector 3 Circuit/Open
- P0204-Fuel Injector 4 Circuit/Open
- P0221-Throttle Position Sensor 2 Circuit Performance
- P0222-Throttle Position Sensor 2 Circuit Low
- P0223-Throttle Position Sensor 2 Circuit High
- P0298-Engine Oil Temperature Too High
- P0300-Multiple Cylinder Misfire
- P0301-Cylinder 1 Misfire
- P0302-Cylinder 2 Misfire
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
