Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Jeep Compass RedFACTORY OEM SERVICE PROCEDURE
Removal And Installation: Installation
- Install the fuel pump assembly using a NEW
tank seal, taking care to align the reference (1a) on the tank with the appendix (1b) of the pump.
- Install the fuel pump assembly mounting ring, by aligning the reference (1a) with the reference (1b) on the tank.
- Mount the 2000002100 (EMEA) or (special tool #9340, SAE Fuel Pump Lock Ring Wrench) (NAFTA) tool (2) and tighten the fuel pump assembly retaining nut.
- Connect the fuel vapor quick coupling.
- Connect the quick coupling of fuel supply hose.
- Connect the wire harness connector to the fuel pump.
- Install the access cover to the fuel pump, tighten the screws and lower the cover.
- Install the rear seat cushion. Refer to SEAT CUSHION, REMOVAL AND INSTALLATION .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.