2022 Jeep Compass RedFACTORY OEM SERVICE PROCEDURE

Removal And Installation: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the shifter bezel. Refer to BEZEL, SHIFTER, REMOVAL AND INSTALLATION .
    GC0202738Courtesy of CHRYSLER GROUP, LLC
  3. Remove the wireless charging pad mat (1).
    GC0202719Courtesy of CHRYSLER GROUP, LLC
  4. Release the retaining tabs (2) and lift up on the rear of the wireless charging module bracket (1).
  5. Slide the bracket (1) toward the rear of the vehicle to release it from the front of the floor console.
  6. Disconnect the wire harness connector (3) from the wireless charging pad module.
    GC0202782Courtesy of CHRYSLER GROUP, LLC
  7. Remove the fasteners (1) from the wireless charging module (2) and remove it from the wireless charging module bracket (3).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.