Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Jeep Compass RedFACTORY OEM SERVICE PROCEDURE
Removal And Installation
REMOVAL
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the left front floor air outlet. Refer to OUTLET, AIR, REMOVAL AND INSTALLATION .
- Disconnect the wire harness connector and camera connectors from the CVPM.
- Remove the fasteners (1) securing the module (2) to the support bracket.
- Remove the CVPM (2) from the vehicle.
- If required, remove the fasteners (1) and remove the CVPM bracket (2).
INSTALLATION
- If removed, position the CVPM bracket and install the fasteners. Tighten the fasteners securely.
- Position the CVPM on the bracket and install the fasteners.
- Connect the wire harness and camera connectors to the CVPM.
- Install the left front floor air outlet. Refer to OUTLET, AIR, REMOVAL AND INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
- Using the diagnostic scan tool, perform the surround view camera programming. Refer to MODULE, CENTRAL VISION PROCESSING (CVPM), MODULE PROGRAMMINGΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
