Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Jeep Cherokee XFACTORY OEM SERVICE PROCEDURE
DTC Index
Select a section or procedure below to view factory instructions:
Circuit Testing ProceduresAmplifier (Amp)Cluster, InstrumentController, Occupant Restraint (Orc)HVAC, ATC - LHDModule, Active Noise Cancellation (ANC)Module, Adaptive Cruise Control (Acc)Module, Antilock Brake (Abs)Module, Adaptive Front Lighting SystemModule, Body Control (BCM)Module, Comfort Seat And Wheel (CSWM)Module, Digital TVModule, Driver Door (DDM), (DMFL/R)Module, Drivetrain Control (DTCM)Module, Electric Parking Brake (EPB)Module, Electric Power Steering (EPS)Module, Electronic Shift (ESM), 948TEModule, Electronic Steering Lock (ESL)Module, External DiscModule, Forward Facing Camera (FFCM)Module, Global Telematics BoxModule, Integrated Center Stack/ScreenModule, Memory Seat, Driver (MSMD)Module, Occupant Classification (OCM)Module, Park Assist (PTS/PAM)Module, Passenger Door (PDM), (DMFL/R)Module, Power Liftgate (PLGM)Module, Powertrain Control (Pcm), 2.0LModule, Powertrain Control (Pcm), 2.4LModule, Powertrain Control (Pcm), 3.2LModule, Radio Frequency (RF Hub)Module, Security Gateway (SGW)Module, Steering Column Control (SCCM)Module, Transmission Control (TCM), 948TE/9HP48Radio, BaseRadio, PremiumSensor, Left Blind Spot (LBSS)Sensor, Right Blind Spot (RBSS)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.