Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Pump Module
Risk of injury to eyes and skin from contact with fuel. Wear protective clothing and eye protection. Risk of poisoning from inhaling and swallowing fuel. Pour fuel only into appropriately marked and approved containers. Failure to follow these instructions may result in possible serious or fatal injury.
- Clean the rubber O-ring seal area of the fuel tank and install a NEWÂ rubber O-ring seal.
- Lower the fuel pump module into the fuel tank using caution not to bend the float arm.
- Align the rubber O-ring seal and rotate the fuel pump module to the orientation marks noted during removal. This step must be performed for the fuel level gauge to work properly.
- Position the lock-ring (3) over top of the fuel pump module (4).
- Position the lock-ring remover/installer (2) (special tool #9340, SAE Fuel Pump Lock Ring Wrench) into the notches on the outside edge of the lock-ring (3).
- Install a 1/2 inch drive breaker bar (1) into the lock-ring remover/installer (2) (special tool #9340, SAE Fuel Pump Lock Ring Wrench).
- Rotate the breaker bar (1) clockwise until all seven notches of the lock-ring (3) have engaged.
- Connect the fuel line (2) to the fuel pump module.
- Connect the fuel tank vapor lines (1, 3) to the fuel pump module.
- Connect the fuel pump module wire harness connector (2, 6). Install the access cover (3, 4) and securely tighten the screws.
- Install the auxiliary fuel pump. Refer to MODULE, FUEL PUMP, INSTALLATIONÂ .
- Install the rear seat. Refer to SEAT, REAR, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
- Use the Scan Tool to pressurize the system and check for leaks.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
