Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal And Installation
REMOVAL
- Disconnect and isolate the negative battery cable.
- Remove the ignition coils. Refer to
COIL, IGNITION, REMOVAL AND INSTALLATION
.NOTE:
Prior to loosening the spark plug, use compressed air to blow out any debris that might be in the spark plug tube.
- Using the appropriate socket, remove the spark plugs (1) from the cylinder head.
INSTALLATION
- Install the spark plug to the cylinder head and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
- Install the ignition coils. Refer to COIL, IGNITION, REMOVAL AND INSTALLATION .
- Connect the negative battery cable.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.