2021 Jeep Grand Cherokee TrackhawkFACTORY OEM SERVICE PROCEDURE

Sensor, Coolant Temperature: Operation: Diesel

At key-on, the Powertrain Control Module (PCM) sends out a regulated 5 volt signal to the ECT sensor. The PCM then monitors the signal as it passes through the ECT sensor to the sensor ground (sensor return).

When the engine is cold, the PCM will operate in Open Loop cycle. It will demand slightly higher idle speeds. This is done until normal operating temperatures are reached.

The PCM uses inputs from the ECT sensor for the following calculations:

  • For engine coolant temperature gauge operation through CAN BUS communications
  • Injector pulse-width
  • ASD relay shut-down times
  • Pulse-width prime-shot during cranking
  • O2 sensor closed loop times
  • EGR solenoid on/off times (if equipped)
  • Radiator fan relay on/off times (if equipped)
  • Target idle speed
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.