Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Radiator, Engine Cooling: Removal: Gas
| 1 - HOSE CLAMP TOOL 6094 |
| 2 - HOSE CLAMP |
Do not remove the cylinder block drain plugs or loosen the radiator draincock with the system hot and under pressure. Serious burns from coolant can occur. Refer to DRAINING .
Do not waste reusable coolant. If the solution is clean, drain the coolant into a clean container for reuse.
Constant tension hose clamps are used on most cooling system hoses. When removing or installing, use only tools designed for servicing this type of clamp. Always wear safety glasses when servicing constant tension clamps.
| 1 - TYPICAL CONSTANT TENSION HOSE CLAMP |
| 2 - CLAMP NUMBER/LETTER LOCATION |
| 3 - TYPICAL HOSE |
A number or letter is stamped into the tongue (2) of constant tension clamps (1). If replacement is necessary, use only an original equipment clamp with matching number or letter.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.