Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Jeep Grand Cherokee TrackhawkFACTORY OEM SERVICE PROCEDURE
Shaft, Intermediate, Lower: Installation
| 1 - INTERMEDIATE SHAFT |
| 2 - MASTER CYLINDER |
CAUTION:
Steering column module is centered to the vehicles steering system. Failure to keep the system and steering column module centered and locked/inhibited from rotating can result in steering column module damage.
- Install the shaft (1) in from the top by the master cylinder (2).
- Install lower intermediate shaft coupler (2) to upper intermediate shaft (1).
- Install bolt (3) and tighten to 42 N.m (31 ft. lbs.).
- Slide lower intermediate shaft coupler onto steering gear pinion shaft (3).
- Install coupler pinch bolt (2) and tighten to 45 N.m (33 ft. lbs.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
