Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Jeep Grand Cherokee TrackhawkFACTORY OEM SERVICE PROCEDURE
Relay, Auto Shut Down: Removal
The Auto Shut Down (ASD) relay is located in the engine compartment within the Power Distribution Center (PDC). Refer to label on power distribution center cover for relay location.
- Remove the PDC cover.
- Remove the ASD relay from the PDC.
- Check the condition of the ASD relay terminals and the PDC connector terminals for damage or corrosion. Repair if necessary before installing the ASD relay.
- Check the ASD relay pin height (pin height should be the same for all terminals within the power distribution center connector). Repair if necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
