Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Coil, Ignition: Installation: 3.6L
- Using compressed air, blow out any dirt or contaminants from around the top of spark plug.
- Check the condition of the ignition coil rubber boot (1). Inspect the opening of the boot (2) for any debris, tears or rips. Carefully remove any debris with a lint free cloth.CAUTION:
Do not apply a silicone based grease such as Mopar® Dielectric Grease to the ignition coil rubber boot. The silicone based grease will absorb into the boot causing it to stick and tear.
- Place a small, 360° bead of Mopar® Molykote G-5008
lubricant (1) along the inside opening of the coil boot approximately 1 to 2 mm from the chamfer edge but not on the chamfered surface.NOTE:
The LH ignition coils are shown, the RH ignition coils are similar.
- Install the ignition coil (2) into the cylinder head cover opening. Using a twisting action, push the ignition coil onto the spark plug. Tighten the bolt(s) (3) to the proper specifications. Refer to TORQUE SPECIFICATIONS .
- Connect the ignition coil wire harness connector (1) and lock connector.
- If removed, install the intake manifold. Refer to MANIFOLD, INTAKE, INSTALLATION .
- Install the air cleaner inlet tube. Refer to INSTALLATION .
- Connect the negative battery cable.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
