2021 Jeep Grand Cherokee TrackhawkFACTORY OEM SERVICE PROCEDURE

Relay, Power Control: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
    GC0175247Courtesy of CHRYSLER GROUP, LLC
  2. Remove the Power Control Relay (PCR) cover (1).
    GC0175214Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the wire harness connector (2) from the PCR.
  4. Remove two nuts (3) and remove the eyelet terminals (1) from the PCR.
    GC0175256Courtesy of CHRYSLER GROUP, LLC
  5. Remove the two nuts that secure PCR (2) to the PCR bracket (1) and remove from the vehicle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.