Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Keyless Go System
The Keyless Go (KG) system changes the state of the vehicle's ignition between the OFF, ACCESSORY, RUN, and START states using a momentary button rather than a conventional key.
The KG system includes the following major components, which are described in further detail elsewhere in this service information:
- FOB with Integrated Key (FOBIK) -. Refer to KEY, TRANSPONDER, DESCRIPTION .
- Passive Entry Antenna - Multiple Low Frequency (LF) antennas are located throughout the passenger compartment. Refer to ANTENNA, PASSIVE ENTRY, DESCRIPTION .
- Remote Frequency Hub (RFH) - The module is located in the drivers rear quarter trim panel. Refer to MODULE, RADIO FREQUENCY (RF HUB), DESCRIPTION .
- Keyless Ignition Node (KIN)
- Located to the right of the steering column and is concealed beneath the instrument panel. Refer to MODULE, KEYLESS IGNITION NODE (KIN), DESCRIPTION
.
.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
