Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Jeep Grand Cherokee TrackhawkFACTORY OEM SERVICE PROCEDURE
Module, Keyless Ignition Node (Kin): Installation
- Install the fasteners (1) securing the KIN module to the bezel.
- Connect the Keyless Ignition Node (KIN) module wiring harness connector (1).
- Install the bezel onto the instrument panel and install the fasteners (1) securing the bezel.
- Install the steering column gap hider and engage the retainers.
- Install the instrument panel center bezel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, INSTALLATION .
- If the KIN was replaced, perform the (Radio Frequency (RF Hub) Module Verification Test. Refer to RADIO FREQUENCY HUB (RF HUB) VERIFICATION TEST .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.