2021 Jeep Grand Cherokee TrackhawkFACTORY OEM SERVICE PROCEDURE

Module, Drivetrain Control (DTCM): Description

GC0145747Courtesy of CHRYSLER GROUP, LLC

The Drive Train Control Module (DTCM (3) is a microcontroller-based assembly, controlling a 4X4 Transfer Case. Communication is via the CAN serial bus. Inputs include user selectable 4X4 modes that include 4WD Full Time (4HI), 4LO, Neutral. The logic and driver circuitry is contained in aluminum housing base and a stamped steel housing cover with an embedded heat sink

The DTCM is installed inside the passenger compartment underneath the driver seat.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.