Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Jeep Grand Cherokee Laredo X, RWDFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| TORQUE SPECIFICATIONS | |||
|---|---|---|---|
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. |
| Seat Belt Turning Loop Adjuster Mounting Screws | 55 | 40 | - |
| Front Seat Belt Turning Loop Mounting Nut | 47 | 35 | - |
| Driver Airbag (Horn Switch) Mounting Screws | 13 | 10 | - |
| Knee AirBag Mounting Nuts | 9 | - | 80 |
| Passenger Airbag Mounting Bolts | 9 | - | 80 |
| Passenger Airbag Mounting Nuts | 10 | - | 89 |
| Seat Airbag Mounting Nuts | 7 | - | 62 |
| Side Curtain Airbag Inflator Bracket Mounting Screws | 8 | - | 71 |
| Side Curtain Airbag Mounting Screws | 8 | - | 71 |
| Front Seat Belt Anchor to Seat | 54 | 40 | - |
| Front Seat Belt Buckle Lower Anchor Mounting Screw | 43 | 32 | - |
| Rear Seat Belt Buckle Anchor Bracket Mounting Screw | 50 | 37 | - |
| Occupant Restraint Controller Mounting Screws | 7 | - | 62 |
| Occupant Restraint Controller Mounting Nut | 8 | - | 71 |
| Front Seat Belt Retractor Mounting Screw | 55 | 40 | - |
| Front Seat Belt Lower Anchor Mounting Screw | 54 | 40 | - |
| Rear Center Retractor Mounting Screw | 43 | 32 | - |
| Rear Center Seat Belt Lower Anchor Mounting Screw | 50 | 37 | - |
| Rear Seat Belt Retractor Mounting Screw | 55 | 40 | - |
| Rear Seat Belt Turning Loop Mounting Screw | 55 | 40 | - |
| Rear Outboard Seat Belt Lower Anchor Mounting Screw | 50 | 37 | - |
| Front Impact Sensor Mounting Screw | 11 | - | 97 |
| Front Door Pressure Impact Sensor Mounting Screws | 2.4 | - | 21 |
| Side Impact Sensor Mounting Screws | 11 | - | 97 |
| Seat Track Position Sensor Mounting Screw | 2 | - | 15 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.