Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Jeep Grand Cherokee L Laredo, AWDFACTORY OEM SERVICE PROCEDURE
Torque Specifications
RESTRAINTS SYSTEM TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | COMMENT |
|---|---|---|---|---|
| B-Pillar Impact Sensor Bolt | 8 | - | 71 | |
| C-Pillar Impact Sensor Bolt | 8 | - | 71 | |
| D-Pillar Impact Sensor Bolt | 8 | - | 71 | |
| Door Impact Sensor | 9 | - | 80 | |
| Driver Knee Airbag Bolt | 15 | 11 | - | |
| Front Impact Sensor Nut | 12 | 9 | - | |
| Front Seat Belt Height Adjuster Bolt | 55 | 41 | - | |
| Front Seat Belt Buckle Bolt | 54 | 40 | - | |
| Front Seat Belt Retractor and Anchor Tensioner Bolt | 55 | 41 | - | |
| Front Seat Belt Retractor Bolt | 48 | 35 | - | |
| Front Seat Belt Turning Loop Nut | 47 | 35 | - | |
| Passenger Airbag Bolt | 6 | - | 53 | |
| Passenger Knee Airbag Bolt | 15 | 11 | - | |
| Seat Airbag Nut | 6 | - | 53 | |
| Second Row Center Seat Belt Buckle Bolt | 40 | 30 | - | |
| Second Row Center Seat Belt Retractor/Anchor Bolt | 55 | 41 | - | |
| Second Row Center Seat Belt Retractor Bolt | 48 | 35 | - | |
| Second Row Left Seat Belt Buckle Bolt | 45 | 33 | - | |
| Second Row Outboard Seat Belt Anchor Bolt | 48 | 35 | - | |
| Second Row Outboard Seat Belt Retractor Bolt | 55 | 41 | - | |
| Second Row Right Seat Belt Buckle Bolt | 45 | 33 | - | |
| Second Row Seat Belt Turning Loop Bolt | 55 | 41 | - | |
| Side Curtain Airbag Screw | 9 | - | 80 | |
| Third Row Retractor Bolt | 48 | 35 | - | |
| Third Row Seat Belt Buckle Bolt | 45 | 33 | - | |
| Third Row Turning Loop Bolt | 48 | 35 | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.