Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Jeep Gladiator Mojave, Part Time T/Case Control, Automatic TransFACTORY OEM SERVICE PROCEDURE
Torque Specification
TORQUE SPECIFICATIONS - STEERING LINKAGE (1 OF 2)
| CALLOUT | DESCRIPTION | SPECIFICATION | COMMENT |
|---|---|---|---|
| 1 | Tie Rod End Nut | 40 N. m + 125° (30 Ft. Lbs. + 125°) | Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| 2 | Drag Link Outer Nut | 40 N. m + 125° (30 Ft. Lbs. + 125°) | Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| 3 | Drag Link Adjuster Clamp | 46 N. m (34 Ft. Lbs.) | - |
| 4 | Drag Link Inner Nut | 39 N. m + 125° (29 Ft. Lbs. + 125°) | Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| 5 | Pitman Arm Nut | 250 N. m (185 Ft. Lbs.) | Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| 6 | Tie Rod End Adjuster Clamp | 46 N. m (34 Ft. Lbs.) | - |
TORQUE SPECIFICATIONS - STEERING LINKAGE (2 OF 2)
| CALLOUT | DESCRIPTION | SPECIFICATION | COMMENT |
|---|---|---|---|
| 1 | Steering Damper Bracket Nut | 75 N. m (55 Ft. Lbs.) | - |
| 2 | Steering Damper Nut | 75 N. m (55 Ft. Lbs.) | - |
| 3 | Steering Damper Bolt | 68 N. m (50 Ft. Lbs.) | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
