Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Jeep Compass TrailhawkFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATION
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | COMMENT |
|---|---|---|---|---|
| Ball Joint Bolts | 66 | 49 | - | |
| Front Stabilizer Bar Bolts | 55 | 41 | - | |
| Hub Nut (FWD/AWD) | 160 | 118 | - | Do NOT reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Front Hub And Bearing Bolts | 98 | 72 | - | Do NOT reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Steering Knuckle Pinch Bolt | 50 | 37 | - | Do NOT reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Lower Control Arm Rear Bolt | 130 + 97° | 96 + 97° | - | Do NOT reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Lower Control Arm Front Bolt | 130 + 97° | 96 + 97° | - | Do NOT reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Stabilizer Bar Link Nuts | 80 | 59 | - | Do NOT reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Strut Upper Mount Bolts | 60 | 44 | - | |
| Strut Lower Bolts | 80 + 97° | 59 + 97° | - | |
| Strut Rod Nut | 70 | 52 | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.