Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Jeep Compass TrailhawkFACTORY OEM SERVICE PROCEDURE
Removal And Installation: Installation
- If necessary, install the ignition control to the lower steering column shroud.
- Position the upper steering column shroud near Instrument Panel Cluster (IPC) and engage the gap hider to the pegs on the upper steering column shroud.
- Position the upper steering column shroud to the steering column then install and tighten the two upper steering column shroud screws.
- Position the lower steering column shroud near the steering column and connect the Keyless Ignition Node (KIN) wire harness connector (1).
- Align the lower steering column shroud (3) to the upper steering column shroud (2) and press the two together to engage plastic lock tabs.
- Install and tighten the three lower steering column shroud screws (1).
- Install the steering column shroud close out tab (1) by pressing it down firmly into the steering column shroud to engage the plastic lock tabs.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.