Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Jeep Compass TrailhawkFACTORY OEM SERVICE PROCEDURE
Chain And Sprockets, Timing: Inspection
Inspect the timing chain for excessive wear prior to removal.
- Rotate the crankshaft clockwise as viewed from the front of the engine while watching the timing chain tensioner plunger. When the plunger reaches its maximum extension, stop rotating the crankshaft.
- Measure the distance from the tensioner body to the edge of the chain guide as shown in illustration (1).
- If the distance (1) is greater than 20.5 mm (0.81 in.) inspect the chain guides for excessive wear.
- If the chain guides are not excessively worn, replace the timing chain. Refer to CHAIN AND SPROCKETS, TIMING, REMOVAL AND INSTALLATIONΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
