Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Jeep Compass Altitude, FWDFACTORY OEM SERVICE PROCEDURE
Diagnostic Test
VERIFY DTC IS ACTIVE
- Turn the ignition on.
- With the scan tool, read the active DTCs.
Does the scan tool display this DTC as active?
Yes
- Refer to DIAGNOSIS AND TESTING and perform the NO RESPONSE FROM BCM (BODY CONTROL MODULE) diagnostic procedure.
No
- Refer to DIAGNOSIS AND TESTING and perform the Stored Lost Communication DTCs diagnostic procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.