Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Module, Body Control (BCM): Description
The Body Control Module (BCM) (1) is mounted in the dashboard, left of the steering wheel, behind a removable aesthetic cover that allows the access to fuses mounted on the component.
The BCM:
- Is the configuration master for the vehicle. As the configuration master, the BCM broadcasts configuration data over the bus whenever the ignition is in the RUN state.
- Receives hardwired input from sensors and switches.
- Provides logic and output control of certain electrical systems.
- Provides load shedding logic and control.
- Is the central gateway module for the Controller Area Network (CAN) and Local Interface Network (LIN) bus networks.
- Supports flashing (reprogramming)
Some functional advantages of the BCM include:
- CAN message optimizations
- Controls all exterior lighting outputs
- Intelligent Battery Sensor (IBS) connection on LIN to the BCM
- Interior Lighting and Dimmable "Mood" Lighting
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
