Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Jeep Cherokee TrailhawkFACTORY OEM SERVICE PROCEDURE
Module, Keyless Ignition Node (Kin): Removal
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the Integrated Center Stack (ICS) Module. Refer to MODULE, INTEGRATED CENTER STACK (ICSM), REMOVALΒ .
- Reaching through the ICS module opening in the instrument panel, disconnect the harness connector (2) from the back of the Keyless Ignition Node (KIN) (3) and position the connector and wire harness out of the way.
- Reaching through the ICS module opening in the instrument panel, remove the fasteners (1) that retain the KIN bracket to the inside of the lower instrument trim panel.
- Remove the KIN (3) with bracket (1).
- Remove the fasteners (1) to separate the KIN (3) from the KIN bracket (2).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
