Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Jeep Cherokee Latitude, 4WDFACTORY OEM SERVICE PROCEDURE
DTC Index
Select a section or procedure below to view factory instructions:
Circuit Testing ProceduresAmplifier (Amp)Cluster, InstrumentController, Occupant Restraint (Orc)HVAC, ATC - LHDModule, Active Noise Cancellation (ANC)Module, Adaptive Cruise Control (Acc)Module, Antilock Brake (Abs)Module, Adaptive Front Lighting SystemModule, Body Control (BCM)Module, Comfort Seat And Wheel (CSWM)Module, Digital TVModule, Driver Door (DDM), (DMFL/R)Module, Drivetrain Control (DTCM)Module, Electric Parking Brake (EPB)Module, Electric Power Steering (EPS)Module, Electronic Shift (ESM), 948TEModule, Electronic Steering Lock (ESL)Module, External DiscModule, Forward Facing Camera (FFCM)Module, Integrated Center Stack/ScreenModule, Memory Seat, Driver (MSMD)Module, Occupant Classification (OCM)Module, Park Assist (PTS/PAM)Module, Passenger Door (PDM), (DMFL/R)Module, Power Liftgate (PLGM)Module, Powertrain Control (Pcm), 2.0LModule, Powertrain Control (Pcm), 2.4LModule, Powertrain Control (Pcm), 3.2LModule, Radio Frequency (RF Hub)Module, Security Gateway (SGW)Module, Steering Column Control (SCCM)Module, Transmission Control (TCM), 948TE/9HP48Radio, BaseRadio, PremiumSensor, Left Blind Spot (LBSS)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
