2021 Jeep Cherokee High Altitude, Automatic T/Case ControlFACTORY OEM SERVICE PROCEDURE

Radiator, Engine Cooling: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Drain the cooling system. Refer to DRAININGΒ  .
    GC0187141Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the lower radiator hose (1).
  4. Remove the cooling fan. Refer to REMOVALΒ  .
    GC0187135Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    The transmission oil cooler lines do not need to be disconnected.

  5. Remove the bolts (1) and position aside the transmission cooler (2).
  6. Disconnect the A/C pressure switch wire harness connector.
    GC0187061Courtesy of CHRYSLER GROUP, LLC
  7. Remove the bolt (1) securing the A/C line to the radiator.
    GC0187037Courtesy of CHRYSLER GROUP, LLC
  8. Remove the nut (1) securing the A/C discharge and liquid line junction block to the bracket (2).
    GC0186773Courtesy of CHRYSLER GROUP, LLC
  9. Remove the four bolts (1) securing the condenser to the radiator and position aside the condenser.
    GC0186371Courtesy of CHRYSLER GROUP, LLC
  10. Remove the two bolts (3) and the upper left side radiator mount cover (4).
  11. Remove the two bolts (2) and the upper right side radiator mount cover (1).
    GC0186542Courtesy of CHRYSLER GROUP, LLC
  12. Pull the radiator forward releasing the isolators (1) from the mount and remove the radiator (2).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.