2021 Jeep Cherokee High Altitude, Automatic T/Case ControlFACTORY OEM SERVICE PROCEDURE

Heater, Engine Block: Installation

  1. Thoroughly clean the engine block core hole and engine block heater seat.
    GC0182733Courtesy of CHRYSLER GROUP, LLC
  2. Insert the engine block heater (1) and engage the clip.
  3. Connect the power cord (2) to the engine block heater.
  4. Install the intake manifold. Refer to INSTALLATION .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.